Bora 2016 service question
Moderator: robbosmans
I'm servicing my Bora Ultra 2016 hubs. Already done with the rear hub.
I have serviced several cup and cone Campa hubs before, but especially the front hub looks a bit different.
How do I remove the dust cap?
I have serviced several cup and cone Campa hubs before, but especially the front hub looks a bit different.
How do I remove the dust cap?
Last edited by havana on Mon Sep 19, 2016 2:57 pm, edited 1 time in total.
Editor-in-chief CycloWorld.cc - the largest database of gran fondo's and sportives in the world.
In the meantime I found the solution. The end cap on the other side (where is tension ring is located) has to be removed. You'll have to block the axle with a wrench 14 mm. It's dead easy, if you know what to do
Editor-in-chief CycloWorld.cc - the largest database of gran fondo's and sportives in the world.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
2016? Why so soon for the service? I took apart my Shimano C50 Dura Ace wheels after 6k miles and the internals looked better than new. I now have the Boras and am not planning on servicing them for a long time.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I have done quite a few kilometers with the wheels in crappy weather so I wanted to see how the bearings looked. They looked like new, so it wasn't really neccesary.
Editor-in-chief CycloWorld.cc - the largest database of gran fondo's and sportives in the world.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com