Keo Blade spindle tool
Moderator: robbosmans
-
- Posts: 1914
- Joined: Mon Feb 05, 2007 5:39 am
- Location: Winnipeg Canada
Hi everyone,
I noticed my pedal ticking again and noticed that the spindle had turned about 1 turn out... On talking to a few online shops there seems to be a special tool that is needed to tighten the spindle which I cant find anywhere... is there an alternative tool for tightening?
Thanks
I noticed my pedal ticking again and noticed that the spindle had turned about 1 turn out... On talking to a few online shops there seems to be a special tool that is needed to tighten the spindle which I cant find anywhere... is there an alternative tool for tightening?
Thanks
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
If the noise is a result of the spindle being loose, you better get it tightened fast - it's plastic on plastic there and pressure from cranking on it when it's loose can cracking the body easily. Use a bit of loctite on it to ensure it stays tight. Do not over-tighten it too!
-
- Posts: 1914
- Joined: Mon Feb 05, 2007 5:39 am
- Location: Winnipeg Canada
I emailed look and they told me it was a 19mm
It is 19mm. I've pulled them apart before.
Colnago C64 - The Naked Build; Colnago C60 - PR99; Trek Koppenberg - Where Emonda and Domane Meet;
Unlinked Builds (searchable): Colnago C59 - 5 Years Later; Trek Emonda SL Campagnolo SR; Special Colnago EPQ
Unlinked Builds (searchable): Colnago C59 - 5 Years Later; Trek Emonda SL Campagnolo SR; Special Colnago EPQ
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com