New to me. SS A-Train frame and fork. Found this frame and fork online with DA Di2 wiring and seatpost battery already installed. Less than 100 miles by owner.
I will weigh the frame and headset along with Di2 wiring before I start assembling.

Frame is constructed out of KVA stainless tubing and lugs.

Component specs:
Di2 Shifter/Brake levers
Enve Stem
Enve Seatpost (27.2)
Shimano 9000 BB
King headset
Thomson Bars (44)
Enve 45 (alchemy hubs) and Enve 25 Wheelsets
Veloflex clinchers (45's) and Veloflex Tubs (25's)
SLR carbon rail saddle
Shimano 7900 11-27 cassette
Shimano 9000 semi compact crank
Lizard skin bar tape
Shimano DA 7900 pedals
EEcyle Works Black brakes with enve pads

this should be good!

Looking nice...

_________________
"It never gets easier, you just go faster..." - Greg Lemond

"I enjoy climbing...I enjoy seeing people disappear behind me." - Robert Millar

Love the frame, but the Enve stem and fork are a bit much with the sleek tubes.

_________________
Bikes: Raw Ti, 650b flatbar CX

+1

_________________
My Renovo R1 wooden bike project and the reason for my passion for all that is wood.

Check it out: the most amazing vintage Colnago, Merckx and Pinarello collection

+2 - especially with such a low profile wheelset (which should suit the build down to a t!).

_________________
Too old to be fast, too young to be this slow!

I'm just waiting for the post to come in and I'll post a couple of updated pics. I installed bars, shifters, brakes on the weekend. I do have the option of using a Syntace black stem but I'm using the fork. I may remove the EDGE logo as a winter project.

Got a few more items installed. Just waiting for Enve seatpost and a set of DA 9000 53/39 rings. I might end up putting on the Syntace stem. I also may try a King stainless cage.

So far it weighs in at 5.7 kg. So it might come in around at 7.2 kg complete with pedals. With the Enve 25's it will weigh around 6.5 ish if my math is correct. I will loose a bit more if I use the Syntace stem and cut the steer tube down a bit.

Why not use a Thomson stem to match the seatpost and bars?

I don't really care for the look of the offset on the Thomson post. It's hard to fit the battery into the post as well. The enve post will be set up to accept the battery.

Updated the pics in the first post. Just need to take it on a few rides before I cut the steer tube.

Weighs 16lbs even.

Now that's very nice....

_________________
CAAD 10

http://weightweenies.starbike.com/forum/viewtopic.php?f=10&t=119755&hilit=caad+10+force+22

Aside from the silly polished headset spacer, this build turned out much nicer than I thought. Very nice!

_________________
My Renovo R1 wooden bike project and the reason for my passion for all that is wood.

Check it out: the most amazing vintage Colnago, Merckx and Pinarello collection

Carbon spacers for sure but I like the look with the Enve fork and stem.

_________________
-For my next trick I will set myself on fire!
-This board and the world in general would be a much nicer place if everyone could just take themselves a little less seriously.
-Sticky Fingers John Rockefeller
-First one over the cliff wins!

I have a set of set of black Chris King spacers somewhere...I will give those a try.