Short mountain bike cranks

Discuss light weight issues concerning mountain bikes & parts.

Moderator: Moderator Team

Post Reply
Posts: 470
Joined: Wed Mar 15, 2017 5:30 pm

by morganb

Are there any options out there at 155mm or below other than SRAM NX? That's what I've been running and they function fine but are an absolute boat anchor and I'm pretty sure they only manufacture them intending to be on nice kids bikes. I've seen one or two older square taper models in that length but those won't work with a number of modern bikes.

Posts: 108
Joined: Sat Mar 13, 2004 5:31 pm

by poynt

only light weight ones I have used are the LIghtnings but they only go down to 160mm.

by Weenie

Posts: 181
Joined: Fri Apr 13, 2007 4:53 pm

by drider85

Again not really that light but Trail Craft come in 140 and 152. Canfield brothers comes down to 155.

Sent from my MotoG3 using Tapatalk

Posts: 444
Joined: Thu Sep 05, 2013 3:29 pm

by TheKaiser

morganb wrote:
Mon Feb 19, 2018 5:56 pm
Are there any options out there at 155mm or below other than SRAM NX?
Don't have an "off the shelf" solution, but you might want to look into options from Rotor. They are going down under 155mm on their new road cranks, and the system is fully modular, with an interchangable spindle and spider. If they are similar to Cannondale and Race Face, then the same arms could be run on road or MTB (or fatbike for that matter) with a simple swap of the spindle and spider. I haven't looked into the spline pattern to see if you could fit compatible MTB parts onto these arms, and I'm sure it wouldn't be cheap, but if you are really committed then it is something to keep in mind: ... k-spindle/

Also, if you aren't afraid of some fabrication, I have seen people running cut down XTRs for this purpose.

Post Reply
  • Similar Topics
    Last post