BB92 pressfit BB + spacer?

[Mads Kock]

I have got a UniTi BB92 pressfit BB for my bike - it comes with a spacer. I have tried mounting it with the spacer but there seems to be some play.

Do any of you use spacers with your BB92 pressfit BB?

Thanks

[eliflap-scalpel]

put other shims to eliminate play and don't care about others ....

ciao Mads

[Mads Kock]

Other shims and don't care about others? Andrea - how many spacers are that? 2?

[eliflap-scalpel]

sorry ...i red you post but my brain red crank not BB .....

try the "gold paper" , thin copper film

[Mads Kock]

Got a standard bb92 from Sram that fits. Gonna have a talk with UniTi because the cup in the driveside was way to loose.

[crazyeddie]

you have to use the 2,5mm spacer on the drive side, if your bottom bracket shell is 89,5mm wide.

[Mads Kock]

Yes - used the spacer. I have located the problem to the cup in the driveside is too small. The Sram fits perfectly with no play but a bit heavier than the UniTi. I'm in contact with the shop so I hope for a good solution.