Help with DT Swiss bushes

Discuss light weight issues concerning mountain bikes & parts.

Moderator: Moderator Team

Post Reply
Posts: 564
Joined: Thu Jan 13, 2011 4:04 pm
Location: Sunny UK

by 02GF74

I have DT Swiss rear shock that I want to fit to Cannondale frame. The overall width of the bushes needs to be 21.8mm and 25.4 mm.

Looking at Chain Reaction website, the only one I found that sells them, I see they are avialable in that size (8mm bolt).

The photo below shows a pair of bushes. Am I correct in thinking the cylindrical part fits into the shock eyelet without a central tube, so the larger diameter end of the bush fits against the frame? Where do the o-ring fit?

(The Rockshox I am replacing has centre tube with two end caps)


Shop Owner
Posts: 1980
Joined: Sat Jun 13, 2009 4:02 am
Location: NoVA/DC

by thisisatest

You are correct, no center tube. The bolt itself is the tube. Small end of the little cone shaped spacers go against the spherical bushing, large end against the frame. O-rings go between the shock bushing and the spacer, to provide a little sealing.

by Weenie

Posts: 214
Joined: Wed Apr 16, 2008 7:43 am
Location: Sapporo City, Hokkaido, Japan

by skyfire1202

The DT-Swiss rear shocks are designed to remove potentially damaging sideload stress from the shock through this "ball and socket bushes" and the O-rings work to provide cushion to this movement - like cartilage on your knee joints.

Post Reply
  • Similar Topics
    Last post